dingoPDM
Settings
CAN Input
Enable
The CAN Input is enabled and evaluated in the device. Setting the unused inputs to not enabled reduces the amount of processing time on the device.
ID
Low Byte
High Byte
Operator
Mask
Mode
Examples
Virtual Input
Enable
The Virtual Input is enabled and evaluated in the device. Setting the unused inputs to not enabled reduces the amount of processing time on the device.
Not
Variable
Condition
Mode
Examples
WiperModule
To control a wiper motor directly from dingoPDM a WiperModule is required. The WiperModule uses 3 relays to properly control the slow, fast and brake functions of a wiper motor. The internal connections are made based on the slow input (which also supplies all power to the motor) and the fast input. The ground and park signals are passed through the module.
Information about the WiperModule can be found here: WiperModule
Wiper
Enable
The Wiper is enabled and evaluated in the device. Setting the unused Wiper to not enabled reduces the amount of processing time on the device.
State
Speed
Slow
Fast
Mode
Slow In
Fast in
Intermittent In
On In
Speed In
Park In
Park Stop Level
Swipe In
Wash In
Wash/Wipe Cycles
Wiper Speed Map
Speed 0-7
Wiper Intermittent Time
Intermittent Time 1- 6
Flasher
Enable
The Flasher is enabled and evaluated in the device. Setting the unused Flahser to not enabled reduces the amount of processing time on the device.
Single
Input
Output
On Time
Off Time
Starter Disable
Enable
The Starter Disable is enabled and evaluated in the device. Setting the unused Starter Disable to not enabled reduces the amount of processing time on the device.